MagForce motor system installation: Difference between revisions
print no crumbs |
|||
| Line 94: | Line 94: | ||
The intelliSwing motor control system must be programmed with the bell at the time of installation. A special hand-held terminal is required for this setup and is available on loan from Chime Master with a deposit. | The intelliSwing motor control system must be programmed with the bell at the time of installation. A special hand-held terminal is required for this setup and is available on loan from Chime Master with a deposit. | ||
* | * If the bell has a proximity sensor for position feedback (chip on control board has a label marked '''PERIOD''' | ||
* If a rotary encoder is installed on the headstock spindles | ** Continue to use this programming procedure | ||
* If a rotary encoder is installed on the headstock spindles (chip on control board has a label marked '''SENSOR''' | |||
** Go to the '''[[ | ** Go to the '''[[IntelliSwing_rotary_sensor_setup#Programming_the_controller|rotary motor programming procedure]]''' | ||
=== Using the Terminal === | === Using the Terminal === | ||