MagForce motor system installation: Difference between revisions
MagForce Precision programming - need a separate page |
|||
| Line 92: | Line 92: | ||
[[File:Intelliswing-terminal.jpg|frameless|right]] | [[File:Intelliswing-terminal.jpg|frameless|right]] | ||
The intelliSwing motor control system must be programmed with the bell at the time of installation. A special hand-held terminal is required for this setup and is available on loan from Chime Master with a deposit. | The intelliSwing motor control system must be programmed with the bell at the time of installation. A special hand-held terminal is required for this setup and is available on loan from Chime Master with a deposit. | ||
* Continue below if the bell has a proximity sensor for position feedback | |||
* If a rotary encoder is installed on the headstock spindles | |||
** Write down that the setting for '''Transmission''' is '''22.8''' | |||
** Go to the '''[[IntelliSwing_Rotary_installation#Programming_the_controller|rotary motor programming procedure]]''' | |||
=== Using the Terminal === | === Using the Terminal === | ||