MagForce motor system installation: Difference between revisions
| Line 56: | Line 56: | ||
== System electrical connections == | == System electrical connections == | ||
Downloadable riser diagrams (pdf suitable for 11x17 paper): | |||
* [[Media:CM-RTWA3T1M3H1G3.pdf|3-Phase, 1-Hammer, 3-intelliSwing MagForce linear motors]] | |||
* [[Media:CM-RTWA3T2M2H2G2.pdf|3-Phase, 2-Hammers, 2-intelliSwing MagForce linear motors]] | |||
=== Power input === | === Power input === | ||
| Line 82: | Line 86: | ||
==== Single phase MagForce panel ==== | ==== Single phase MagForce panel ==== | ||
The MagForce control panel for single phase will have a capacitor on the output between outputs ''U'' and ''V''. If the motor is sized to require an overload protector, the ''W'' connection will be routed in a serpentine fashion through the three disconnect circuits. This is required to prevent trips caused by the missing phase detection. | The MagForce control panel for single phase will have a capacitor on the output between outputs ''U'' and ''V''. If the motor is sized to require an overload protector, the ''W'' connection will be routed in a serpentine fashion through the three disconnect circuits. This is required to prevent trips caused by the missing phase detection. | ||
== Programming Procedure == | == Programming Procedure == | ||