MagForce motor system installation: Difference between revisions

(One intermediate revision by the same user not shown)

Line 94:

The MagForce control panel for single phase will have a capacitor on the output between outputs ''U'' and ''V''. If the motor is sized to require an overload protector, the ''L1'' connection to the triac input will be routed in a serpentine fashion through the three overload circuits. This is required to prevent trips caused by the missing phase detection.

== Programming Procedure ==

== Programming Procedure (PERIOD proximity) ==

~~[[File~~:~~Intelliswing-terminal.jpg|frameless|right]]~~

IMPORTANT:

The intelliSwing motor control system must be programmed with the bell at the time of installation. A special hand-held terminal is required for this setup and is available on loan from Chime Master with a deposit.

* If the bell has a proximity sensor for position feedback (chip on control board has a label marked '''PERIOD''')

** Then continue to use this programming procedure.

* If a rotary encoder is installed on the headstock spindles (chip on control board has a label marked '''SENSOR''')

** Then go to the '''[[IntelliSwing_rotary_sensor_setup#Programming_the_controller|rotary sensor programming procedure]]''' and use the parameter options there for MagForce Linear motors.

* If the bell with a proximity sensor is being serviced (chip on control board has a label marked '''PERIOD''')

** Then continue to use this programming procedure

=== Using the Terminal ===

~~[[File:Intelliswing-termcon.jpg|frameless|right]]~~

~~Connect the programming terminal and turn on panel power.~~

The right cursor button will take you through the settings for each bell in the system. From the status window, shown below, you can cursor left to select another bell. To change settings you can increment/decrement using the up and down arrow buttons, or input the value with the numeric buttons and save it with the EXE button.

@@ Line 94: / Line 94: @@
 The MagForce control panel for single phase will have a capacitor on the output between outputs ''U'' and ''V''. If the motor is sized to require an overload protector, the ''L1'' connection to the triac input will be routed in a serpentine fashion through the three overload circuits. This is required to prevent trips caused by the missing phase detection.
-== Programming Procedure ==
+== Programming Procedure (PERIOD proximity) ==
-[[File:Intelliswing-terminal.jpg|frameless|right]]
+IMPORTANT:
-The intelliSwing motor control system must be programmed with the bell at the time of installation. A special hand-held terminal is required for this setup and is available on loan from Chime Master with a deposit.
-* If the bell has a proximity sensor for position feedback (chip on control board has a label marked '''PERIOD''')
-** Then continue to use this programming procedure.
 * If a rotary encoder is installed on the headstock spindles (chip on control board has a label marked '''SENSOR''')
 ** Then go to the '''[[IntelliSwing_rotary_sensor_setup#Programming_the_controller|rotary sensor programming procedure]]''' and use the parameter options there for MagForce Linear motors.
+* If the bell with a proximity sensor is being serviced (chip on control board has a label marked '''PERIOD''')
+** Then continue to use this programming procedure
 === Using the Terminal ===
-[[File:Intelliswing-termcon.jpg|frameless|right]]
-Connect the programming terminal and turn on panel power.
 The right cursor button will take you through the settings for each bell in the system. From the status window, shown below, you can cursor left to select another bell. To change settings you can increment/decrement using the up and down arrow buttons, or input the value with the numeric buttons and save it with the EXE button.