Chime Master Help

Bell Control Technical Data 3700: Difference between revisions

← Older editNewer edit →
Output wiring
config switches
Line 242: Line 242:


This application requires '''DAMPER''' firmware installed on the interface module.
This application requires '''DAMPER''' firmware installed on the interface module.
* set panel address switches the same as the striker module
* set the Panel Configuration switches the same as the striker output panel
* set map switches the same as the striker module
* set high baud ON (only available with AX controller)


Refer to the [[Bell_Control_Technical_Data_3700#Adjust_output_pulse_time|pulse setting instructions]] above to adjust the transition time between notes while in the self test mode. This is a single setting for all notes in the chime (unlike striker pulse timing). Exiting self test mode will save the adjustment permanently to non-volatile memory.
Refer to the [[Bell_Control_Technical_Data_3700#Adjust_output_pulse_time|pulse setting instructions]] above to adjust the transition time between notes while in the self test mode. This is a single setting for all notes in the chime (unlike striker pulse timing). Exiting self test mode will save the adjustment permanently to non-volatile memory.
Retrieved from "https://help.chimemaster.com/p/Bell_Control_Technical_Data_3700"