MagForce motor system installation: Difference between revisions
| Line 35: | Line 35: | ||
=== Precision rotary movement sensor (option) === | === Precision rotary movement sensor (option) === | ||
The rotary encoder is mounted to a non-moving part (A-stand) with pulleys and belt to sense the angular movement of the swinging bell axle. | The rotary encoder is mounted to a non-moving part (A-stand) with pulleys and belt to sense the angular movement of the swinging bell axle. A value to enter for the Transmission parameter in the program will be provided based on the pulley diameters. | ||
For rotary encoder systems, verify that the label on the CPU chip of the motor control system says "SENSOR." | A separate logic translation board is supplied in a weatherproof box and may be used as a junction box at the bell location. | ||
There are four wires in the encoder cable: | |||
Green to input '''A''' on the translator | |||
Gray to input '''B''' on the translator | |||
Brown to input '''+V''' on the translator | |||
White to input '''0V''' on the translator | |||
The translator outputs wire one to one to the motion controller sensor inputs: '''P''' (pulse), '''D''' (direction), '''+''' (positive power), '''-''' (negative power). | |||
For rotary encoder systems, verify that the label on the CPU chip of the motor control system says "SENSOR." Use the [[IntelliSwing_Rotary_installation#Programming_the_controller|rotary motor programming procedure]]. | |||
== System electrical connections == | == System electrical connections == | ||