MagForce motor system installation: Difference between revisions
| Line 131: | Line 131: | ||
* If the bell swings too high on the first pulse, reduce power in the %Start and/or PowerStaSwi parameters. | * If the bell swings too high on the first pulse, reduce power in the %Start and/or PowerStaSwi parameters. | ||
* If the bell seems to be fighting itself to get started, experiment with smaller values of %Start (length of start pulse). | * If the bell seems to be fighting itself to get started, experiment with smaller values of %Start (length of start pulse). | ||
* If you get ''Err MaxAmpli'' then there is some reason the bell isn't coming back to the home position in a reasonable amount of time. Check for friction in the bearings or a lack of rigidity in the reactor plate so that it doesn't get pulled into the motor and cause mechanical braking action. | * If you get ''Err MaxAmpli'' then there is some reason the bell isn't coming back to the home position in a reasonable amount of time. Check for friction in the bell pivot bearings or a lack of rigidity in the reactor plate so that it doesn't get pulled into the motor and cause mechanical braking action. | ||
* If you get ''ErrBlo'' (blocked bell): | * If you get ''ErrBlo'' (blocked bell): | ||
** It may need more starting pulses to exit the sensor. Try increasing StaImp (number of allowed blind pulses). | ** It may need more starting pulses to exit the sensor. Try increasing StaImp (number of allowed blind pulses). | ||