MagForce motor system installation: Difference between revisions

Line 129:

* If the bell isn't swinging high enough to ring, but the controller stops sending impulses to the motor during CalcImp, then increase Angle.

* If the bell kicks too high on the first pulse, reduce power in the %Start and PowerStaSwi parameters.

* If the bell seems to be fighting itself to get started, experiment with %Start.

* If the bell seems to be fighting itself to get started, experiment with smaller values of %Start.

* If you get ''ErrBlo'' (blocked bell)~~, maybe it needs~~ more pulses to ~~start, try~~ increasing StaImp

* If you get ''ErrBlo'' (blocked bell):

** It may need more pulses to exit the sensor. Try increasing StaImp.

** Check that you properly set the 1Oscillation above. If it is still 900, you did not complete the procedure. Do it again.

* When ''Swing'' appears on the display, the system has calculated the ideal impulse (middle value on the lower line on the status screen) to swing the bell. If you would like the bell to swing higher or lower, try other values for Angle and MaxAmpli. It will recalculate the ideal impulse based on changes you make at this time.

* When you like the angle and the display again says ''Swing'' you can press '''ON''' to stop the bell swinging. Wait for the bell to come to a full stop.

@@ Line 129: / Line 129: @@
 * If the bell isn't swinging high enough to ring, but the controller stops sending impulses to the motor during CalcImp, then increase Angle.
 * If the bell kicks too high on the first pulse, reduce power in the %Start and PowerStaSwi parameters.
-* If the bell seems to be fighting itself to get started, experiment with %Start.
+* If the bell seems to be fighting itself to get started, experiment with smaller values of %Start.
-* If you get ''ErrBlo'' (blocked bell), maybe it needs more pulses to start, try increasing StaImp
+* If you get ''ErrBlo'' (blocked bell):
+** It may need more pulses to exit the sensor. Try increasing StaImp.
+** Check that you properly set the 1Oscillation above. If it is still 900, you did not complete the procedure. Do it again.
 * When ''Swing'' appears on the display, the system has calculated the ideal impulse (middle value on the lower line on the status screen) to swing the bell. If you would like the bell to swing higher or lower, try other values for Angle and MaxAmpli. It will recalculate the ideal impulse based on changes you make at this time.
 *  When you like the angle and the display again says ''Swing'' you can press '''ON''' to stop the bell swinging. Wait for the bell to come to a full stop.