MagForce motor system installation: Difference between revisions

Line 88:

For proximity (period) sensor systems, set the transmission value to 5.0. In order to calibrate the angle of the bell to the swinging period, set the Oscillation value as follows:

* Go to the 1Oscillation screen and press the ON button - the display will say ''Measure''

* Go to the 1Oscillation screen and press the '''ON''' button - the display will say ''Measure''

* Swing the bell by hand or by using the '''EXE''' key to pulse (single direction) to a little more than 20 degrees. Make sure that the M light is blinking on the control board. If not, check the light on the rear of the proximity sensor. Check the sensor connections. The period at the top of the screen should change from the default value of 900 to the actual swinging period of the bell.

* when bell has coasted to about 20 degrees, watch for the period to update then press the '''ON''' key to save it current period

* when bell has coasted to about 20 degrees, watch for the period to update then press the '''ON''' key to save it current period. The display will say ''Stop'' and the top period will remain static.

* this measurement is not critical except if it is off then

#The angle that you select below will not be the true angle, but if you can get the bell to ring properly, don't be overly concerned with the number

@@ Line 88: / Line 88: @@
 For proximity (period) sensor systems, set the transmission value to 5.0. In order to calibrate the angle of the bell to the swinging period, set the Oscillation value as follows:
-* Go to the 1Oscillation screen and press the ON button - the display will say ''Measure''
+* Go to the 1Oscillation screen and press the '''ON''' button - the display will say ''Measure''
 * Swing the bell by hand or by using the '''EXE''' key to pulse (single direction) to a little more than 20 degrees. Make sure that the M light is blinking on the control board. If not, check the light on the rear of the proximity sensor. Check the sensor connections. The period at the top of the screen should change from the default value of 900 to the actual swinging period of the bell.
-* when bell has coasted to about 20 degrees, watch for the period to update then press the '''ON''' key to save it current period
+* when bell has coasted to about 20 degrees, watch for the period to update then press the '''ON''' key to save it current period. The display will say ''Stop'' and the top period will remain static.
 * this measurement is not critical except if it is off then
 #The angle that you select below will not be the true angle, but if you can get the bell to ring properly, don't be overly concerned with the number