Tower bells setup MS: Difference between revisions
flesh out |
completed |
||
| Line 24: | Line 24: | ||
=== Coasting delay === | === Coasting delay === | ||
The tolling hammers are locked for bells that are swinging, but after the motors are turned off, their hammers should be locked until the bells come to a full stop. In the absence of motion feedback, the number at the lower left of the window parameter should be set to the number of seconds the largest bell takes to stop after its motor is turned off. The default value is 120 seconds. The maximum is 240 seconds (four minutes). | The tolling hammers are locked for bells that are swinging, but after the motors are turned off, their hammers should be locked until the bells come to a full stop. In the absence of motion feedback, the number at the lower left of the window parameter should be set to the number of seconds the largest bell takes to stop after its motor is turned off. The default value is 120 seconds. The maximum is 240 seconds (four minutes). | ||
== Save settings == | |||
To save these settings, you must pull down the ''Device'' menu and select ''Install Tower Bells Option and Settings''. The system will reboot when this is complete. | |||
[[Category:Bell automation]][[Category:Management Suite]] | [[Category:Bell automation]][[Category:Management Suite]] | ||