MagForce motor system installation: Difference between revisions

← Older edit Newer edit →

@@ Line 91: / Line 91: @@
 === Automatic calculation ===
-The bell needs to be swung twice (full automatic setting) so the controller can experiment with the required pulses. These parameters will only be saved after the bell has been rung twice. The first time it will say ‘Start’ then ‘Calc-Imp’ then ‘Restart’. The second time will say ‘Start’ then ‘Calc-P’ then 'Swing.' The calculated parameters are not saved until the status display reads 'Swing.'
+The bell needs to swing two times (full automatic setting) so the controller can experiment with the required pulses. These parameters will only be saved after the bell has been rung twice.
+The first time it will say ‘Start’ then ‘Calc-Imp’ then ‘Start.' After you stop the motor the status display will read 'Restart.'
+The second time will say ‘Start’ then ‘Calc-P’ then 'Swing.' The calculated parameters are not saved until the status display reads 'Swing.' After you stop the motor the status display will read 'Stop.' The calculated parameters are saved in non-volatile memory, so power can be safely turned off at this point.
 ==== First Swing Test ====