MagForce motor system installation: Difference between revisions
| Line 54: | Line 54: | ||
* when bell has coasted to about 20 degrees, watch for the period to update then press the ON key to save it current period | * when bell has coasted to about 20 degrees, watch for the period to update then press the ON key to save it current period | ||
* this measurement is not critical except if it is off then | * this measurement is not critical except if it is off then | ||
#The angle that you select below will not be the true angle, but if you can get the bell to ring properly, don't be overly concerned with the number | |||
#If you set the Oscillation angle too high, the start period will be too long and the bell may fight against the period at start up. It is better to set the oscillation period to an angle that the motor can reasonably reach with the start pulses than an accurate 20 degrees. | |||
=== Select Swing Angle and other constants === | === Select Swing Angle and other constants === | ||