MagForce motor system installation: Difference between revisions
make clear this setup method is for PERIOD proximity sensors |
|||
| Line 94: | Line 94: | ||
The MagForce control panel for single phase will have a capacitor on the output between outputs ''U'' and ''V''. If the motor is sized to require an overload protector, the ''L1'' connection to the triac input will be routed in a serpentine fashion through the three overload circuits. This is required to prevent trips caused by the missing phase detection. | The MagForce control panel for single phase will have a capacitor on the output between outputs ''U'' and ''V''. If the motor is sized to require an overload protector, the ''L1'' connection to the triac input will be routed in a serpentine fashion through the three overload circuits. This is required to prevent trips caused by the missing phase detection. | ||
== Programming Procedure == | == Programming Procedure (PERIOD proximity) == | ||
IMPORTANT: | IMPORTANT: | ||
* If a rotary encoder is installed on the headstock spindles (chip on control board has a label marked '''SENSOR''') | * If a rotary encoder is installed on the headstock spindles (chip on control board has a label marked '''SENSOR''') | ||