Main Menu MS SixSS: Difference between revisions

(settings for sixss)
(status ready)
Line 41: Line 41:
== Status Bar ==
== Status Bar ==


Normally the left side of the status bar will say it is Ready. Some features require the carillon to enter a dedicated communications mode called Slave Mode when writing to FLASH memory. Switching between slave and ready modes may cause the carillon to reboot, resulting momentary delay. The status bar at the bottom of the application screens indicates the current mode of the carillon.
Normally the left side of the status bar will say it is Ready. Some features require the ringing system to enter a dedicated remote communications mode when writing to FLASH memory. Switching between FLASH and Ready modes may cause the controller to reboot, resulting momentary delay. The status bar at the bottom of the application screens indicates the current mode of the bell system.


At the right end of the status bar you can see the schedule status. If a macro schedule has become active it will be displayed so you know which one is currently active. If the schedule edit mode has uploaded the schedule it will say Schedule Loaded.
At the right end of the status bar you can see the schedule status. If a macro schedule has become active it will be displayed so you know which one is currently active. If the schedule edit mode has uploaded the schedule it will say Schedule Loaded.

Revision as of 16:58, 6 February 2017


Click on the menu buttons below for instructions and descriptions for each Management Suite application.

Suite-5-10-menu-free.pngWeekly SchedulerJukebox ConcertRemote Control PanelSettings menuBackup and RestoreFirmware UpdateMusic Library Update

This is the Main Menu for the Free Management Suite.

Depending on the capabilities of your Chime Master system and its firmware revision, you may have fewer or additional buttons compared to the panels above.

Buttons will gray out if the carillon is in a mode that cannot support them (such as when it is playing).

Menu Customization

Right clicking your mouse in the button area of the main menu allows you to customize the menu. You can hide the details panel displayed on the right of the window, resize buttons and hide buttons you don’t use. The default button sizes are handy for a touch screen, but feel free to make them smaller if you always use a mouse.

Holding the left mouse button over an icon button allows you to re-position it in the menu.

Carillon Model Details

Other information pertaining to the connected carillon will be displayed in the upper right-hand box. A customer service representative may request these if you call for technical support. You can hide this box by right-clicking on the panel and de-selecting View-Details.

  • M = Hardware Model
  • F = Firmware Version (MMYY)
  • L = Library Catalog Version
  • V = Voices indicates voicing
  • D = Clock Dial interface (Y/N)

(T and R options are not applicable to the SixSS carillon)

Status Bar

Normally the left side of the status bar will say it is Ready. Some features require the ringing system to enter a dedicated remote communications mode when writing to FLASH memory. Switching between FLASH and Ready modes may cause the controller to reboot, resulting momentary delay. The status bar at the bottom of the application screens indicates the current mode of the bell system.

At the right end of the status bar you can see the schedule status. If a macro schedule has become active it will be displayed so you know which one is currently active. If the schedule edit mode has uploaded the schedule it will say Schedule Loaded.

Always make USB connections to the carillon before starting Management Suite. Allow a few seconds after connecting for the drivers to load.