USB connections to bell systems: Difference between revisions
| Line 34: | Line 34: | ||
These instructions describe setting up a Silex Network USB interface to work over the WiFi network. The requirements are a Laptop PC with a wired network interface and a crossover cable (supplied with the Silex).<br> | These instructions describe setting up a Silex Network USB interface to work over the WiFi network. The requirements are a Laptop PC with a wired network interface and a crossover cable (supplied with the Silex).<br> | ||
*Turn on wireless access point | * Turn on wireless access point | ||
*Turn off wifi on Technician PC | * Turn off wifi on Technician PC | ||
*Use crossover CAT5 cable to connect Silex to Technician PC | * Use crossover CAT5 cable to connect Silex to Technician PC | ||
*Power ON the Silex holding the reset button until the Status light comes on | * Power ON the Silex holding the reset button until the Status light comes on | ||
*Run DSsetup.exe | * Run Device Server Setup (DSsetup.exe) (download from Silex [http://www.silexamerica.com/products/support/device-networking/sx-ds-3000wn/ support website]) | ||
**Configure using the Setup Utility: | ** Configure using the Setup Utility: | ||
**Fill out top MAC info with Silex serial number | ** Fill out top MAC info with Silex serial number | ||
**Select the Silex device - Next > - Next > | ** Select the Silex device - Next > - Next > | ||
**The Silex will search for the access point | ** The Silex will search for the access point | ||
**Select the access point and enter its password - Next > | ** Select the access point and enter its password - Next > | ||
**Execute and select NO for software installation - Finish and exit | ** Execute and select NO for software installation - Finish and exit | ||
*Cycle Power on the Silex | * Cycle Power on the Silex | ||
Installed PC setup | |||
*Load the Silex SX Virtual Link onto the | * Load the Silex SX Virtual Link onto the host PC using the appropriate installer from [http://www.silexamerica.com/campaign/sx-virtual-link-downloads/ this web page]. | ||
*Install the latest Management Suite on customer's PC | * Install the latest Management Suite on customer's PC | ||
*Plug the carillon into the Silex - the Millennium driver should install | * Plug the carillon into the Silex - the Millennium driver should install | ||
*Start the Management Suite | * Start the Management Suite | ||
*Bring up the remote panel. You should see the system display working normally. | * Bring up the remote panel. You should see the system display working normally. | ||
=== More Secure Solutions === | === More Secure Solutions === | ||