Network setup AX: Difference between revisions
Jodivandyke (talk | contribs) |
Jodivandyke (talk | contribs) |
||
| Line 16: | Line 16: | ||
=== Access Point === | === Access Point === | ||
The AX line was designed to be connected to the internet, but if none is available at your facility, you can still use the [[Remote_AX|remote control]]. | The AX line was designed to be connected to the internet, but if none is available at your facility, you can still use the [[Remote_AX|remote control]]. | ||
* While the Platinum AX is [[ | * While the Platinum AX is [[Operate_AX_products|powered off]], plug in the included wireless antenna into the top right USB port on the back, then restart the unit. | ||
* From the home page of the Platinum AX, choose Settings then Network. At the top, you can view if you are connected via an Ethernet cable or a wireless network. If your unit is connected to WiFi, first tap Disconnect. If this is not updated after several minutes, exit the page and go through the steps again. Recycling the power may also help successfully disconnect. | * From the home page of the Platinum AX, choose Settings then Network. At the top, you can view if you are connected via an Ethernet cable or a wireless network. If your unit is connected to WiFi, first tap Disconnect. If this is not updated after several minutes, exit the page and go through the steps again. Recycling the power may also help successfully disconnect. | ||
* Once you are successfully disconnected, you can turn on the Access Point switch in the lower left corner of the screen. It may take several minutes for the system to accurately display the Access Point status. | * Once you are successfully disconnected, you can turn on the Access Point switch in the lower left corner of the screen. It may take several minutes for the system to accurately display the Access Point status. | ||
* Return to the home page of the Platinum AX then choose Remote. | * Return to the home page of the Platinum AX then choose Remote. | ||
* After entering your PIN, the system will check its network connection status. You will be asked to connect your smart phone or other device to a password protected CMS WiFi. On the next screen of the Platinum, you will scan the new QR code with your phone’s camera or QR reader. Tap the link which is provided from the QR code to open the Access Point Remote in your phone’s browser. | * After entering your PIN, the system will check its network connection status. You will be asked to connect your smart phone or other device to a password protected CMS WiFi. On the next screen of the Platinum, you will scan the new QR code with your phone’s camera or QR reader. Tap the link which is provided from the QR code to open the Access Point Remote in your phone’s browser. | ||