Set system clock setup menu: Difference between revisions
LX Backup circuit recharge |
|||
| (3 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
<div style="font-size:84%">'''[[Chime_Master_Help|Help]] > [[Operating manuals]] '''</div> | |||
This menu is found on all Chime Master bell ringing equipment with a two line display and sixteen button keypad. It is used to make corrections to the time clock. | This menu is found on all Chime Master bell ringing equipment with a two line display and sixteen button keypad. It is used to make corrections to the time clock. | ||
Temperature compensated crystal clock circuitry gives the clock accuracy greater than +/- two minutes per year. Periodic checks and settings of the clock may be necessary to insure accurate operation of the system. The clock is factory set to your local time before shipment and should not require setting at the time of installation. | Temperature compensated crystal clock circuitry gives the clock accuracy greater than +/- two minutes per year. Periodic checks and settings of the clock may be necessary to insure accurate operation of the system. The clock is factory set to your local time before shipment and should not require setting at the time of installation. | ||
LX Ringing systems: If the system has not been powered for some time, the backup capacitor will need to charge before you can set the clock. Allow 20-30 minutes after powering the system for charging. | |||
== Open the | == Open the Menu == | ||
Open the Time strike/auto level setup menu by pressing the front panel green ''Enter'' button so that you read ''Main Menu'' on the top line of the display. Press any gray cursor button until the flashing lower line reads ''System Setup Menu'' then press the ''Enter'' button again. | Open the Time strike/auto level setup menu by pressing the front panel green ''Enter'' button so that you read ''Main Menu'' on the top line of the display. Press any gray cursor button until the flashing lower line reads ''System Setup Menu'' then press the ''Enter'' button again. | ||
| Line 18: | Line 20: | ||
The minute will be blinking. Use the cursor left and right buttons to move around the display (and cause other elements to blink). Change the settings for the blinking element using the cursor up and down buttons. | The minute will be blinking. Use the cursor left and right buttons to move around the display (and cause other elements to blink). Change the settings for the blinking element using the cursor up and down buttons. | ||
== Set the | == Set the Time == | ||
Use the cursor right button to make ''Set Time'' blink, then press the green ''Enter'' button when you want to start the clock from the selected time. | Use the cursor right button to make ''Set Time'' blink, then press the green ''Enter'' button when you want to start the clock from the selected time. | ||
| Line 24: | Line 26: | ||
The display will read ''Setting real time clock'' while it restarts the clock. | The display will read ''Setting real time clock'' while it restarts the clock. | ||
=== Tower | === Tower Clock Movement Hand Position === | ||
This section only applies to systems that are controlling an external clock movement. | This section only applies to systems that are controlling an external clock movement. | ||
| Line 39: | Line 41: | ||
Press ''Enter'' to restart the tower clock. It should wait or catch up to the current time. | Press ''Enter'' to restart the tower clock. It should wait or catch up to the current time. | ||
== Exit the | == Exit the Menu == | ||
After you have finished setting the time, press the red ''Cancel'' button to return to the automatic standby mode. | After you have finished setting the time, press the red ''Cancel'' button to return to the automatic standby mode. | ||
[[category:manual]] | [[category:manual]] | ||