DA3862 Deagan Solid State Action: Difference between revisions
fix link |
|||
| (8 intermediate revisions by 3 users not shown) | |||
| Line 1: | Line 1: | ||
A solid state replacement for the original Deagan electro-mechanical relay module used on the 67 type Tower Chime action. | A solid state replacement for the original Deagan electro-mechanical relay module used on the 67 type Tower Chime action. | ||
<embedvideo service="youtube">https://www.youtube.com/watch?v=fTZdGqqGh2g</embedvideo> | |||
== Features == | |||
[[File:3862.png|150px|frameless|right|Deagan 67 SS Action Controller]] | [[File:3862.png|150px|frameless|right|Deagan 67 SS Action Controller]] | ||
* High current coil outputs with active back-EMF quenching | * High current coil outputs with active back-EMF quenching | ||
** Optional third output for 67-O type Action | ** Optional third output for 67-O type Action | ||
| Line 14: | Line 13: | ||
== Advantages == | == Advantages == | ||
* Faster repeat times (should be used with our suspension cable stabilizers) | * Faster repeat times (should be used with our suspension cable stabilizers) | ||
* Quieter operation (especially with removal of old reversing switch mechanism) | |||
* Simple Installation | * Simple Installation | ||
* Spark free operation | * Spark free operation | ||
| Line 21: | Line 21: | ||
== Installation == | == Installation == | ||
[[File:Striker3861.jpg|150px|frameless|right|Deagan 67 Hookup]] | |||
* Remove old relay from top of the Deagan 67 action. | * Remove old relay from top of the Deagan 67 action. | ||
** Optionally remove bottom contacts and actuating arm to reduce friction. | ** Optionally remove bottom contacts and actuating arm to reduce friction and noise. | ||
* Move coil return leads to positive terminal block (module coil outputs are negative) | * Move coil return leads to positive terminal block (module coil outputs are negative) | ||
* Move the head toward the chime. Replace the retraction cup with the new cup. Orient the cup so that the sensor cable exits the top. Tighten the cup bolt. | * Move the head toward the chime. Replace the retraction cup with the new cup. Orient the cup so that the sensor cable exits the top. Tighten the cup bolt. | ||
| Line 35: | Line 36: | ||
* Press the TEST MODE button to select the test mode (1 to 3 times) | * Press the TEST MODE button to select the test mode (1 to 3 times) | ||
* Press the TEST MODE button to cancel tests | * Press the TEST MODE button to cancel tests | ||
* Adjust the THRUST control clockwise for longer strike pulses. Reducing THRUST | * Adjust the THRUST control clockwise for longer strike pulses. Reducing THRUST allows faster repeat times and lower chime ringing intensity. | ||
Test Modes | Test Modes | ||
* ERROR/MODE light not blinking - single strike | * ERROR/MODE light not blinking - single strike | ||